1. Product wrinkles
(1) The pressure of the rubber roller is too large, causing the film to deform, and the pressure should be appropriately reduced.
(2) The surface of the rubber roller is damaged or uneven, and the rubber roller should be replaced.
(3) The pressure between the rubber roller and the heating roller is not balanced and should be adjusted appropriately.
(4) If the tension on both sides of the film is inconsistent or there is a wavy edge, the film material should be replaced.
2. The product appears snowflake
(1) The pressure of the rubber roller is not enough, and the pressure should be increased appropriately.
(2) The gel on the precoat film is not completely melted and can be solved by the following method.
1 Increase the film temperature appropriately.
2 Increasing the contact area between the film and the heating roller, so that the degree of heat fusion of the adhesive on the film at the same speed is increased.
3 reduce the film speed.
(3) Dust and impurities on the rubberized surface of the pre-coated film should be removed in time.
3. Bonding is not strong, release film
(1) The precoat film is over the shelf life and a new precoat film is replaced.
(2) If the ink layer of the printed matter is not dry, the drying time of the printed matter should be prolonged, especially when coating the special printed matter.
(3) The film pressure is small, the speed is fast, and the temperature is low. The film pressure can be appropriately increased, the film speed can be lowered, and the film temperature can be increased.
4. Product curl after slitting
(1) If the film tension is too large, the film will be stretched and deformed, and the film tensioning screw should be adjusted.
(2) The winding tension is large, so that the film and paper are deformed at the same time, and the winding tensioning mechanism should be adjusted.
(3) The humidity in the production workshop should be controlled at about 60%.
(4) If the drying time is short, the drying time should be extended appropriately. After the film-coated product is completely dried and cooled on the winding roller, the film is cut and cut.
Euro Fence introduction:
The horizontal Wire is wavy so that the resistance more stronger. Installation for Dutch Post with special circle clamps.
Euro Fence Characteristic:
Euro fence packing in rolls, loading conveniently, installation speedly.
Euro Fence Specification:
wire diameter: 2.0mm, 2.5mm, 3.0mm
mesh size: 50*50mm, 50*100mm
height: 1m, 1.2m, 1.5m, 1.8m, 2.0m
length: 20m, 25m, 30m
Euro fence appplication:
Euro fence popular in Industry zone, Countyard, Villadom, Public grounds, Farm, Highway, Railway, city
Euro fence surface treatment: galvanized wire then PVC coating(thickness 0.8-1.2mm)
Euro Fence
Coated Euro Fence,Wire Mesh Fence,Welded Mesh Fence,Pvc Euro Fence
Anping Deming Metal Net Co.,Ltd , https://www.wovenfence.nl